LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2018 >> Spark LT, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Manual Transmission - Y4A/Y4M) >> Repair Instructions - Off Vehicle >> Shift Shaft and Fork Assemblies Disassemble >> 1st-2nd Gear Shift Shaft Disassemble

1st-2nd Gear Shift Shaft Disassemble

WARNING: This page is about a different variant/trim than selected.
  1. GM2493600Courtesy of GENERAL MOTORS COMPANY

    Remove the gear unit. Refer to Transmission Disassemble .

  2. Remove the 1st-2nd gear shift shaft assembly from the gear unit.
  3. Fix the shift shaft assembly into a vise with a protector.
    4. NOTE:

    Mark the place and direction of the shift fork and yoke before removing them. This will aid the reassembly.

  4. Remove the 1st-2nd gear shift yoke pin (1) using a pin punch and a hammer.
  5. Remove the 1st-2nd gear shift yoke (2).
  6. Remove the 1st-2nd gear shift fork pin (3) using a pin punch and a hammer.
  7. Remove the 1st-2nd gear shift fork (4).
scientia non olet · About LEMON Manuals