Steering Linkage Outer Tie Rod Replacement

WARNING: This page is about a different car, the 2017 Chevrolet Spark. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Steering Linkage Outer Tie Rod

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
Preliminary Procedures Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle . Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
1	Steering Linkage Inner Tie Rod Nut CAUTION: Refer to Fastener Caution . NOTE: Mark the position of the steering linkage inner tie rod nut before removing to aid in installation. Tighten 75 N.m (55 lb ft)
2	Steering Linkage Outer Tie Rod Nut Tighten First Pass: 30 N.m (22 lb ft) Final Pass: Additional 120 - 130 degrees
3	Steering Linkage Outer Tie Rod Procedure Use CH-24319-B steering linkage and tie rod puller to separate the steering linkage outer tie rod from the steering knuckle. Clean the tapered surface of the steering knuckle. Inspect the steering linkage inner tie rod for bent or damaged threads. If necessary, replace the steering linkage inner tie rod. Refer to Steering Linkage Inner Tie Rod Replacement Measure and adjust the front toe. Refer to Wheel Alignment - Steering Wheel Angle and/or Front Toe Adjustment . Calibrate the steering angle sensor. Refer to Steering Wheel Angle Sensor Centering . Special Tools CH-24319-B Steering Linkage and Tie Rod Puller For equivalent regional tools, refer to Special Tools .