Installation Procedure
WARNING: This page is about a different car, the 2017 Chevrolet Spark. However, it is still accessible from the selected car via links, so may be relevant.
- Install the power vacuum brake booster assembly (1) to the vehicle.
- Install the brake, accelerator and clutch pedal bracket nuts (1) retaining the power vacuum brake booster assembly and tighten to 22 N.m (16 lb ft).
- Connect the brake booster pushrod (3) to the brake pedal.
- Install the retaining clip (1) and pin (2) to the brake pedal.
- Install the I/P knee bolster. Refer to Instrument Panel Knee Bolster Replacement .
- Install the power vacuum brake booster check valve and hose assembly to the brake booster grommet. Refer to Power Brake Booster Vacuum Check Valve and Hose Replacement (LHD) .
- Install the brake master cylinder assembly. Refer to Master Cylinder Replacement (LHD) .
- Bleed the hydraulic brake system. Refer to Hydraulic Brake System Bleeding (Manual) Hydraulic Brake System Bleeding (Pressure) .
CAUTION:
Refer to Fastener Caution .