LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2018 >> Spark LT, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 62 (Hydraulic Brake System) >> Repair Instructions >> Brake and Accelerator Pedal Assembly Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2017 Chevrolet Spark. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the steering column upper trim cover. Refer to Steering Column Upper Trim Cover Replacement .
  2. Remove the steering column lower trim cover. Refer to Steering Column Lower Trim Cover Replacement .
  3. Remove the I/P knee bolster. Refer to Instrument Panel Knee Bolster Replacement .
  4. Remove the intermediate steering shaft. Refer to Intermediate Steering Shaft Replacement .
  5. Remove the steering column assembly. Refer to Steering Column Replacement .
  6. Disconnect the electrical connectors from the accelerator pedal and brake pedal position sensor, if equipped.
    7. Fig 1: Retaining Clip, Pin And Brake Booster Pushrod
    GM4114299Courtesy of GENERAL MOTORS COMPANY
  7. Remove the retaining clip (1) and pin (2) from the brake pedal.
  8. Disconnect the brake booster pushrod (3) from the brake pedal.
    9. Fig 2: Brake/Accelerator Pedal Assembly And Bracket Nuts
    GM4114311Courtesy of GENERAL MOTORS COMPANY
  9. Remove the brake and accelerator pedal bracket nuts (1).
  10. Remove the brake and accelerator pedal assembly (2) from the vehicle.
  11. Remove the following components from the brake and accelerator pedal assembly, as necessary.
    • Accelerator pedal assembly
    • Brake pedal position sensor or brake pedal position switch
    • Brake pedal assembly
scientia non olet · About LEMON Manuals