LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2018 >> Spark LT, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 59 (Engine Mechanical - 1.4L (LV7) - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Engine Flywheel Replacement (LV7) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2017 Chevrolet Spark. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the clutch pressure and driven plate. Refer to Clutch Pressure and Driven Plate Replacement .
  2. Remove the starter. Refer to Starter Replacement (without Start/Stop)Starter Replacement (LV7) .
  3. Install the EN-51760  holder (2), lock the flywheel via the starter ring gear.
    Fig 1: Engine Flywheel Holding Tool And Starter Bolt
    GM4036579Courtesy of GENERAL MOTORS COMPANY
  4. Install the starter bolt (1).
  5. Remove the 8 flywheel bolts (2).
    Fig 2: Engine Flywheel And Bolts
    GM3763307Courtesy of GENERAL MOTORS COMPANY
  6. Remove the flywheel (1).
scientia non olet · About LEMON Manuals