LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2018 >> Spark LT, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 59 (Engine Mechanical - 1.4L (LV7) - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Camshaft Cover Replacement (LV7) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2017 Chevrolet Spark. However, it is still accessible from the selected car via links, so may be relevant.
  1. Open the hood.
  2. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
  3. Remove the air cleaner outlet duct. Refer to Air Cleaner Outlet Duct Replacement (LV7) .
  4. Disconnect the fuel injector connectors. Refer to Fuel Injection Fuel Rail Assembly Replacement (LV7) .
  5. Disconnect the any electrical connectors to set aside the engine main control wiring harness from camshaft cover.
  6. Remove the ignition coil. Refer to Ignition Coil Replacement (LV7) .
  7. Remove the camshaft position sensor. Refer to Camshaft Position Sensor Replacement (LV7) .
  8. Remove the camshaft position actuator solenoid valve. Refer to Camshaft Position Actuator Solenoid Valve Replacement (LV7) .
  9. Remove the engine lift front bracket (1), engine cover bracket (2), engine lift rear bracket (3) and engine pressure oxygen sensor bracket (4).
    Fig 1: Engine Lift Front/Rear Brackets, Engine Cover Bracket And Engine Pressure Oxygen Sensor Bracket
    GM4230601Courtesy of GENERAL MOTORS COMPANY
  10. Remove the vacuum pump. Refer to Vacuum Pump Assembly Replacement (LV7) .
  11. Remove the oil level indicator. Refer to Oil Level Indicator Replacement (LV7) .
  12. Remove the ball stud (1) from the camshaft cover.
    Fig 2: Camshaft Cover Ball Studs
    GM4230603Courtesy of GENERAL MOTORS COMPANY
  13. Remove the 4 camshaft cover stud bolts (1).
    Fig 3: Camshaft Cover, Stud Bolts And Bolts
    GM4230604Courtesy of GENERAL MOTORS COMPANY
  14. Remove the 13 camshaft cover bolts (2).
  15. Remove the camshaft cover (3).
  16. Remove the camshaft cover gasket (1).
    Fig 4: Camshaft Cover, Gasket And Seals
    GM4230608Courtesy of GENERAL MOTORS COMPANY
scientia non olet · About LEMON Manuals