LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2018 >> Spark LT, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 58 (Transmission Cooling System) >> Repair Instructions >> Transmission Fluid Cooler Pipe Connector Replacement - Radiator >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2017 Chevrolet Spark. However, it is still accessible from the selected car via links, so may be relevant.
  1. Inspect the new O-ring seals for cracks, cuts or damage. Replace if necessary.
  2. Install the oil cooler fitting to the radiator and tighten to 20 N.m (15 lb ft).
    Fig 1: View Of Oil Cooler Fitting At Radiator
    GM1443001Courtesy of GENERAL MOTORS COMPANY
    CAUTION: Refer to Fastener Caution .
    NOTE: The correct thread engagement is critical. Cross-threaded fittings can achieve proper tightness and still leak.
  3. Install the transmission oil cooler pipes to the oil cooler fittings on the radiator. Refer to Transmission Fluid Cooler Hose/Pipe Quick-Connect Fitting Disconnection and Connection .
  4. Fill the cooling system. Refer to Cooling System Draining and Filling .
  5. Adjust the transmission fluid level. Refer to Transmission Fluid Drain and Fill (Maintenance)Transmission Fluid Drain and Fill (Repair) .
  6. Inspect for fluid leaks.
scientia non olet · About LEMON Manuals