LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2018 >> Spark LT, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 56 (Automatic Transmission - JATCO CVT) >> Repair Instructions - On Vehicle >> Range Selector Lever Cable Bracket Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2017 Chevrolet Spark. However, it is still accessible from the selected car via links, so may be relevant.
  1. Set the park brake and chock the wheels.
  2. Without draining the coolant or removing the hoses, remove and position aside the radiator surge tank. Refer to Radiator Surge Tank Replacement .
  3. Remove the ECM from the battery tray. Refer to Engine Control Module Replacement .
  4. Remove the battery positive cable retainer (1) from the range selector lever cable bracket.
    Fig 1: Battery Positive Cable Retainer
    GM4204275Courtesy of GENERAL MOTORS COMPANY
  5. Disconnect the transmission range selector lever cable terminal (1) from the transmission range selector lever.
    Fig 2: Transmission Range Selector Lever Cable Terminal
    GM4112708Courtesy of GENERAL MOTORS COMPANY
  6. Disconnect the range selector lever cable (2) from the range selector lever cable bracket.
  7. Remove the transmission range selector cable bracket bolts (1).
    Fig 3: Transmission Range Selector Cable Bracket Bolts
    GM4112716Courtesy of GENERAL MOTORS COMPANY
  8. Remove the transmission range selector cable bracket (2).
scientia non olet · About LEMON Manuals