LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2018 >> Spark LT, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 55 (Manual Transmission - Y4A/Y4M (MR7)) >> Repair Instructions - On Vehicle >> Shift Control Housing Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2017 Chevrolet Spark. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the battery tray. Refer to Battery Tray Replacement (without Engine Block Heater)Battery Tray Replacement (with Engine Block Heater) .
  2. Without draining the coolant or removing the hoses, remove and position aside the radiator surge tank. Refer to Radiator Surge Tank Replacement .
  3. Remove the shift lever and selector lever cable from shift control housing. Refer to Manual Transmission Shift Lever and Selector Lever Cable Replacement .
  4. Remove the shift interlock washer (2) and bolt (1).
    Fig 1: Shift Interlock Washer And Bolt
    GM4039111Courtesy of GENERAL MOTORS COMPANY
    NOTE: Certainly remove the shift interlock bolt. Otherwise, shift control housing assembly cannot be removed.
  5. Remove the 4 shift control housing bolts (1).
    Fig 2: Shift Control Housing Assembly And Bolts
    GM4039113Courtesy of GENERAL MOTORS COMPANY
    NOTE: Shift the transmission into NEUTRAL.
  6. Remove the shift control housing assembly (2) from the transmission.
  7. Remove the sealant on the shift control housing and the transmission case.
scientia non olet · About LEMON Manuals