Installation Procedure

WARNING: This page is about a different car, the 2017 Chevrolet Spark. However, it is still accessible from the selected car via links, so may be relevant.

Clean the water pump threads.
Install a NEW water pump housing gasket (3).

Fig 1: Water Pump Assembly
Courtesy of GENERAL MOTORS COMPANY
Install the water pump assembly (2).
Install the 3 water pump bolts (1) and tighten to 25 N.m (18 lb ft).
CAUTION: Refer to Fastener Caution .
Install a NEW engine coolant thermostat housing gasket (3).

Fig 2: Engine Coolant Thermostat Housing Gasket And Bolts
Courtesy of GENERAL MOTORS COMPANY
Install the engine coolant thermostat housing (2).
Install the coolant thermostat housing bolts (1) and tighten to 10 N.m (89 lb in).
Install the thermostat bypass pipe bolts (1) and bracket bolt (2) and tighten to 10 N.m (89 lb in).

Fig 3: Thermostat Bypass Pipe Bolts And Bracket Bolt
Courtesy of GENERAL MOTORS COMPANY
Connect the refrigerant pressure sensor connector (1) and compressor clutch connector (2).

Fig 4: Refrigerant Pressure Sensor Connector And Compressor Clutch Connector
Courtesy of GENERAL MOTORS COMPANY
Install the catalytic converter heat shield cover (2).

Fig 5: Catalytic Converter Heat Shield Cover And Bolt
Courtesy of GENERAL MOTORS COMPANY
Install the catalytic converter heat shield cover bolts (1) and tighten to 9 N.m (80 lb in)
Connect the radiator outlet clamp (1) and hose (2).

Fig 6: Radiator Outlet Clamp And Hose
Courtesy of GENERAL MOTORS COMPANY
Install the drive belt. Refer to Drive Belt Replacement (L5Q) .
Fill the engine cooling system. Refer to Cooling System Draining and Filling .
Start the engine and check for coolant leaks.