Rear Bumper Valance Panel Replacement (Dual Tail Pipe)

Callout	Component Name
Preliminary Procedure Rear Bumper Fascia Replacement (Single Tail Pipe) Rear Bumper Fascia Replacement (Dual Tail Pipe)
1	Rear Bumper Valance Panel Bolt[2x] CAUTION: Refer to FASTENER CAUTION . Tighten 2.5N.m (22 lb in)
2	Rear Bumper Valance Panel Clip [4x]
3	Rear Bumper Valance Panel Procedure Carefully push a small nylon wedge between the lower fascia and the rear bumper valance panel. Insert a small flat-bladed tool into the fascia slot and depress the snaps one at a time and pull on the fascia at the same time to gradually remove the upper fascia from the rear bumper valance panel. Transfer components as necessary.