LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2018 >> Malibu LS >> Repair and Diagnosis >> Body & Frame >> Exterior Body Panels >> Bumpers And Fascias >> Repair Instructions >> Rear Bumper Fascia Replacement (Dual Tail Pipe)

Rear Bumper Fascia Replacement (Dual Tail Pipe)

GM4289066
Callout Component Name
Preliminary Procedures 
REAR WHEELHOUSE LINER REPLACEMENT
1 Rear Bumper Fascia Bolt [2x]
CAUTION:

Refer to FASTENER CAUTION .


Tighten 
2.5 N.m (22 lb in)
2 Rear Bumper Fascia Nut[2x]
Tighten 
2.5 N.m (22 lb in)
3 Rear Bumper Fascia Retainer[2x]
4 Rear Bumper Fascia

Procedure

  1. Carefully push a small nylon wedge between the fascia and the rear fascia guide. Insert a small flat-bladed tool into the fascia slot and depress the snaps one at a time and pull on the fascia at the same time to gradually remove the fascia from the rear fascia guide.
  2. Disconnect all electrical connectors.
  3. Transfer components as necessary.
scientia non olet · About LEMON Manuals