LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2018 >> Impala Premier, Gas >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Engine Controls And Fuel - 2.5L (LCV) - Repair Instructions) >> Repair Instructions >> Evaporative Emission Line Replacement - Engine to Chassis >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
  1. GM2820659

    Install the evaporative emission pipe (1) to the vehicle.

  2. Connect the evaporative emission pipe (1) and install to the retainers (2). Refer to Plastic Collar Quick Connect Fitting Service .
  3. If equipped, install the right rear underbody air deflector. Underbody Rear Air Deflector Replacement - Right Side
  4. If equipped, install the right front underbody air deflector. Underbody Front Air Deflector Replacement - Right Side (Tire)Underbody Front Air Deflector Replacement - Right Side (XFE)
  5. Lower the vehicle.
  6. GM2815570

    Install the evaporative emission pipe (1) to the retainers (2).

  7. Install the evaporative emission front pipe. Refer to Evaporative Emission Front Pipe Replacement .
scientia non olet · About LEMON Manuals