4 - 5 - 6 Clutch Piston Removal

WARNING: This page is about a different variant/trim than selected.

Callout	Component Name
1	4-5-6 Clutch Dam Retaining Ring NOTE: The 4-5-6 clutch dam retaining ring is not reusable. Special Tools DT-47951-2 Spring Compressor - 6T40/45/50 DT-48903 Spring Compressor - 6T30 GE 5586-A Snap Ring Pliers or equivalent Equivalent regional tools:Special Tools
2	4 - 5 - 6 Clutch Piston Fluid Dam Procedure Place the 3 - 5 reverse and 4 - 5 - 6 clutch housing onto the support hub in the case. Apply shop air to the 4 - 5 - 6 clutch feed hole using a rubber tipped air gun to dislodge the dam piston and the 4 - 5 - 6 clutch piston from the clutch housing.
3	4 - 5 - 6 Clutch Piston Return Spring
4	4 - 5 - 6 Clutch Piston NOTE: Apply shop air to the 4 - 5 - 6 clutch feed hole using a rubber tipped air gun to dislodge the clutch piston.
5	4 - 5 - 6 Clutch Piston Inner Seal
6	4 - 5 - 6 Clutch Piston Outer Seal (Dark Blue) (Stepped)
7	4 - 5 - 6 Clutch Piston Outer Seal (Large) (Rounded)