Installation Procedure
WARNING: This page is about a different variant/trim than selected.
Install the transmission range selector cable bracket (3).
- Install the transmission range selector cable bracket bolts (1, 2) and tighten to 22 N.m (16 lb ft).
Connect the range selector cable (2) to the range selector cable bracket.
- Connect the range selector cable end (1) to the range selector lever.
- Check the range selector cable adjustment. Refer to Range Selector Lever Cable Adjustment .
- Place the engine control module back to its installed position. Refer to Engine Control Module Replacement .
CAUTION:
Refer to Fastener Caution .