LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2018 >> Equinox L >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 7 (Engine Controls And Fuel - 2.0L (LTG) - Repair Instructions) >> Repair Instructions >> Fuel Pump Cover Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Fuel Pump Shield Bolt
    GM4676116Courtesy of GENERAL MOTORS COMPANY
  1. Install Fuel Pump Cover (2)
    2. CAUTION:

    Refer to Fastener Caution .

  2. Install Fuel Pump Shield Bolt (1) and tighten [3x] 10 N.m (89 lb in)
    3. Fig 2: Electrical Connector
    GM4676113Courtesy of GENERAL MOTORS COMPANY
  3. Connect Electrical Connector (1) @ Fuel Pump.
    4. Fig 3: Engine Wiring Harness Retainer And Fuel Pump Cover
    GM4676100Courtesy of GENERAL MOTORS COMPANY
  4. Install Engine Wiring Harness Retainer (1) @ Fuel Pump Cover (2)
  5. Install Intake Manifold Cover Intake Manifold Cover Replacement
  6. Install Install Charge Air Cooler Outlet Air Tube - Charge Air Cooler Outlet Air Tube Replacement 
scientia non olet · About LEMON Manuals