LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2018 >> Equinox L >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Engine Mechanical - 2.0L (LTG)) >> Repair Instructions - On Vehicle >> Engine Oil Level Indicator Switch Replacement (FWD) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Remove Lower Oil Pan -Lower Oil Pan Replacement 
    2. Fig 1: Electrical Connector And Engine Oil Level Indicator Switch
    GM5125367Courtesy of GENERAL MOTORS COMPANY
  2. Disconnect Electrical Connector (1) @ Engine Oil Level Indicator Switch (2)
  3. Remove Engine Oil Level Indicator Switch Bolt (3)
    4. Fig 2: Engine Oil Level Sensor Lead Clip And Sensor Connector
    GM5125372Courtesy of GENERAL MOTORS COMPANY
  4. Remove Engine Oil Level Sensor Lead Clip (1)
  5. Push the sensor connector (2) through the oil pan.
    6. Fig 3: O-Ring Seal And Engine Oil Level Indicator Switch
    GM5125373Courtesy of GENERAL MOTORS COMPANY
  6. Disconnect Engine Oil Level Indicator Switch (1) @ Oil Pump Flow Control Solenoid Valve Wire Clip (2)
  7. Remove Engine Oil Level Indicator Switch (1)
    8. NOTE:

    This step is necessary only if reusing the old engine oil level indicator switch.

  8. Engine Oil Level Indicator Switch O-Ring Seal (3) and DISCARD
scientia non olet · About LEMON Manuals