LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2018 >> Equinox L >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Engine Mechanical - 2.0L (LTG)) >> Repair Instructions - On Vehicle >> Engine Oil Level Indicator Switch Replacement (AWD) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Remove the oil pan cover. Oil Pan Cover Replacement 
    2. Fig 1: Oil Level Sensor Connector And Fasteners
    GM3924857Courtesy of GENERAL MOTORS COMPANY
  2. Disconnect the engine oil level indicator switch electrical connector (1).
  3. Remove the 2 engine oil level indicator switch fasteners (2).
    4. Fig 2: Engine Oil Level Sensor Connector And C-Clip
    GM3924868Courtesy of GENERAL MOTORS COMPANY
  4. Remove the engine oil level indicator switch C-clip (1).
    5. NOTE:

    Use wire or suitable device to route the indicator switch connector through the oil pan opening.

  5. Push the engine oil level indicator switch connector (2) through the oil pan to remove.
    6. Fig 3: Engine Oil Level Sensor And O-Ring
    GM3924895Courtesy of GENERAL MOTORS COMPANY
  6. Remove the engine oil level indicator switch (1) from the oil pan.
    7. NOTE:

    This step is necessary only if reusing the old engine oil level indicator switch.

  7. Remove Engine Oil Level Indicator Switch O-Ring Seal and DISCARD
scientia non olet · About LEMON Manuals