LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2018 >> Equinox L >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Engine Mechanical - 2.0L (LTG)) >> Repair Instructions - On Vehicle >> Crankshaft Balancer Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Crankshaft Balancer Remover, Breaker Bar And Fastener
    GM3971349Courtesy of GENERAL MOTORS COMPANY
  1. Install the crankshaft balancer with NEW fastener. Use EN-51577-1  Crankshaft Balancer Remover (1) and breaker bar (2) prevent the crankshaft from rotating while tightening the NEW crankshaft balancer fastener (3).
    2. CAUTION:

    Refer to Fastener Caution .

  2. tighten the crankshaft balancer bolt to 150 N.m (111 lb ft) plus an additional 140 degrees using the EN-45059  meter.
  3. Install the drive belt. Drive Belt Replacement 
  4. Perform the crankshaft position variation learn procedure. Crankshaft Position Variation Learn
scientia non olet · About LEMON Manuals