Camshaft Cover Heat Shield Replacement

WARNING: This page is about a different variant/trim than selected.

Fig 1: Camshaft Cover Heat Shield

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
Preliminary Procedures Intake Manifold Cover Replacement Turbocharger Heat Shield Replacement Disconnect and reposition the engine wiring harness.
1	Camshaft Cover Heat Shield Bolt [4x] CAUTION: Refer to Fastener Caution . tighten 10 N.m (89 lb in)
2	Camshaft Cover Heat Shield Procedure Disconnect the camshaft position actuator solenoid valve. NOTE: When removing the camshaft cover heat shield, carefully guide the shield past the turbocharger coolant return and PCV pipes.

Callout

Component Name

Preliminary Procedures

Camshaft Cover Heat Shield Bolt [4x]

CAUTION:

tighten
10 N.m (89 lb in)

Camshaft Cover Heat Shield
Procedure
Disconnect the camshaft position actuator solenoid valve.

NOTE:

When removing the camshaft cover heat shield, carefully guide the shield past the turbocharger coolant return and PCV pipes.