LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2018 >> Equinox L >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Mechanical - 1.6L (LH7) Diesel) >> Repair Instructions - On Vehicle >> Turbocharger Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Remove the air cleaner outlet duct. Refer to Air Cleaner Outlet Duct Replacement
  2. Remove Oxidation Catalytic Converter. Refer to Oxidation Catalytic Converter Replacement (LH7)
  3. Drain the cooling system. Refer to Cooling System Draining and Filling (GE 47716)Cooling System Draining and Filling (Static)
  4. Remove Turbocharger Wastegate Actuator Pipe. Refer to Turbocharger Wastegate Actuator Pipe Replacement
    5. Fig 1: Charge Air Cooler Inlet Air Tube And Retaining Clip
    GM4695617Courtesy of GENERAL MOTORS COMPANY
  5. Disconnect Charge Air Cooler Inlet Air Tube (2) @ Turbocharger. Refer to Charge Air Cooler Inlet Air Tube Replacement
    6. Fig 2: Wiring Harness Retainer And Electrical Connector
    GM4421774Courtesy of GENERAL MOTORS COMPANY
  6. Remove Wiring Harness Retainer (2)
  7. Disconnect the electrical connector. (1)
    8. Fig 3: Turbocharger Oil Feed Pipe, Hollow Screw And Gaskets
    GM4377188Courtesy of GENERAL MOTORS COMPANY
  8. Remove Turbocharger Oil Feed Pipe Hollow Screw (2)
  9. Remove and DISCARD the gaskets. (3) (Qty: 2)
    10. Fig 4: Turbocharger Coolant Feed Pipe Hollow Screw And Gaskets
    GM4421777Courtesy of GENERAL MOTORS COMPANY
  10. Remove Turbocharger Coolant Feed Pipe Hollow Screw (1)
  11. Remove and DISCARD the gaskets. (2) (Qty: 2)
    12. Fig 5: Turbocharger Heat Shield, Bolts And Clamp
    GM4377126Courtesy of GENERAL MOTORS COMPANY
  12. Remove Turbocharger Heat Shield Bolts (1) (Qty: 2)
  13. Unclip Turbocharger Heat Shield (2) @ Clamp (3)
  14. Remove Turbocharger Heat Shield (2)
    15. Fig 6: Turbocharger Coolant Feed Hose, Feed Pipe, Clamp, Stud And Nut
    GM4421778Courtesy of GENERAL MOTORS COMPANY
  15. Loosen Turbocharger Coolant Feed Hose Clamp (4)
  16. Disconnect Turbocharger Coolant Feed Hose (5) @ Turbocharger Coolant Feed Pipe (3)
  17. Remove Turbocharger Coolant Feed Pipe (3) @ Stud (2)
  18. Remove Turbocharger Nut (1)
  19. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle
    20. Fig 7: Turbocharger Oil Return Pipe Bolts
    GM4421776Courtesy of GENERAL MOTORS COMPANY
  20. Loosen Turbocharger Oil Return Pipe Bolt (2)
  21. Remove Turbocharger Oil Return Pipe Bolt (1)
    22. Fig 8: Turbocharger Nuts
    GM4421779Courtesy of GENERAL MOTORS COMPANY
  22. Remove Turbocharger Nuts (1) (Qty: 2)
  23. Lower the vehicle.
    24. Fig 9: Turbocharger Assembly And Gaskets
    GM4421780Courtesy of GENERAL MOTORS COMPANY
  24. Remove Turbocharger Assembly (1)
  25. Remove and DISCARD the gaskets. (2, 3) (Qty: 2)
    26. Fig 10: Turbocharger Oil Feed Pipe, Hollow Screw, Bolt And Gaskets
    GM4421781Courtesy of GENERAL MOTORS COMPANY
  26. Remove Turbocharger Oil Feed Pipe Hollow Screw (1)
  27. Remove and DISCARD the gaskets. (2) (Qty: 2)
  28. Remove Turbocharger Oil Feed Pipe Bolt (4)
  29. Remove Turbocharger Oil Feed Pipe (3)
    30. Fig 11: Turbocharger Coolant Feed Pipe, Bolts And Gasket
    GM4421782Courtesy of GENERAL MOTORS COMPANY
  30. Remove Turbocharger Coolant Feed Pipe Bolts (1) (Qty: 2)
  31. Remove Turbocharger Coolant Feed Pipe (3)
  32. Remove and DISCARD the gasket. (2)
scientia non olet · About LEMON Manuals