Conditions for Running the DTCs
WARNING: This page is about a different variant/trim than selected.
P142B, P1435
- DTC P142C, P142D, P142E, P142F, P1474, P1475, P1476, P1477, P1478, P16D7, P16D8, P16D9, P24B0, P24B1, P24B3, P24B5, P24B6, P24D0 or U02A3 is not set.
- The ignition is ON and the engine is not cranking.
- The ignition voltage is greater than 11 V.
- The reductant control module relay 2 is commanded ON.
The DTCs run continuously when the above conditions are met.
P142C, P142D, P142E, P142F, P1436
- DTC P16D7, P16D8, P16D9, P24D0 or U02A3 is not set.
- The ignition is ON and the engine is not cranking.
- The ignition voltage is greater than 11 V.
- The reductant control module relay 2 is commanded ON.
The DTCs run continuously when the above conditions are met.