LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2018 >> Equinox L >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 19 (Engine Controls And Fuel - 1.6L (LH7) Diesel - Diagnostic Information And Procedures (P040B - P204D)) >> Diagnostic Information And Procedures >> DTC P1051 Or P1052: Reductant Heater 1-2 Driver High Temperature >> Component Testing >> Reductant Line Heater

Reductant Line Heater

WARNING: This page is about a different variant/trim than selected.
  1. Ignition Off, disconnect the harness connector at the E52 Reductant Line Heater.
    2. NOTE:

    The DMM and test leads must be calibrated to 0 Ω in order to prevent misdiagnosis.

  2. Test for 1 - 2 Ω between terminals 1 - 2 at the E52 Reductant Line Heater.
    • If less than 1 Ω or greater than 2 Ω 

      Replace the E52 Reductant Line Heater.

    • Go to next step: If between 1 - 2 Ω 
  3. Test for infinite resistance between each terminal and the E52 Reductant Line Heater housing/case.
    • If less than infinite resistance 

      Replace the E52 Reductant Line Heater.

    • Go to next step: If infinite resistance 
  4. All OK.
scientia non olet · About LEMON Manuals