Circuit/System Verification
WARNING: This page is about a different variant/trim than selected.
- Ignition On.
- Verify that DTC P203C or P203D is not set.
- If a DTC Is set
Refer to DTC P203C or P203D .
- Go to next step: If no DTC is set
- If a DTC Is set
- Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
- Verify DTC P1050 does not set.
- If the DTC sets
Refer to Circuit/System Testing
- Go to next step: If no DTC sets
- If the DTC sets
- All OK.