Component Testing
WARNING: This page is about a different variant/trim than selected.
- Ignition OFF, disconnect the harness connector at the Q61 Reductant Injector.
- Test for 10 - 14 Ω between the high control circuit terminal 2 and low control circuit terminal 1.
- If not within 10 - 14 Ω
Replace the Q61 Reductant Injector
- Go to next step: If within 10 - 14 Ω
- If not within 10 - 14 Ω
- Test for infinite resistance between each terminal and the sensor housing/case.
- If less than infinite resistance
Replace the Q61 Reductant Injector.
- Go to next step: If infinite resistance
- If less than infinite resistance
- All OK.