Circuit/System Verification
WARNING: This page is about a different variant/trim than selected.
- Verify the scan tool Reductant Injector Control Circuit Status parameters listed below display OK or Not Run.
- Reductant Injector Control Circuit Open Status
- Reductant Injector Control Circuit Low Voltage Test Status
- If OK or Not Run is not displayed
Refer to Circuit/System Testing.
- Go to next step: If OK or Not Run is displayed
- Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
- Verify DTC P1048, P1049, P2047, P2048 or P2049 does not set.
- If any of the DTCs sets
Refer to Circuit/System Testing.
- Go to next step: If no DTC sets
- If any of the DTCs sets
- All OK.