LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2018 >> Equinox L >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 19 (Engine Controls And Fuel - 1.6L (LH7) Diesel - Diagnostic Information And Procedures (P040B - P204D)) >> Diagnostic Information And Procedures >> DTC P1029, P102A, Or P102B: Fuel Pump Phase U-V-W Circuits >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different variant/trim than selected.
  1. Ignition - On/Vehicle - In Service Mode
  2. Verify DTC U18A2 is not set.
    • Go to next step: If the DTC is not set 
  3. Verify the scan tool parameter:
    • Fuel Pump Phase U-V-W Circuits High Voltage Test Status = OK or Not Run
    • Fuel Pump Phase U-V-W Circuits Low Voltage Test Status = OK or Not Run
    • Fuel Pump Phase U-V-W Circuits Open Test Status = OK or Not Run
    • If not the specified state 

      Refer to Circuit/System Testing

    • Go to next step: If the specified state 
  4. Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.

    Verify the DTC does not set.

    • If the DTC sets 

      Refer to Circuit/System Testing

    • Go to next step: If the DTC is not set 
  5. All OK.
scientia non olet · About LEMON Manuals