Conditions for Setting the DTC
WARNING: This page is about a different variant/trim than selected.
P1015
The reductant control module detects a low circuit fault on the signal circuit for greater than 1 s.
P1016
The reductant control module detects a high circuit fault on the signal circuit for greater than 1 s.
P1017
The reductant control module detects a performance fault on the signal circuit for greater than 1 s.
P1018
The reductant control module detects a short to ground on the 5 V reference circuit for greater than 1 s.
P1019
The reductant control module detects a short to voltage on the 5 V reference circuit for greater than 1 s.
P101A
The reductant control module detects a short to voltage on the low reference circuit for greater than 1 s.