Conditions for Running the DTC
WARNING: This page is about a different variant/trim than selected.
P1015, P1016
- DTC U010E is not set.
- The engine is running.
- The ignition voltage is greater than 11 V.
- The reductant control module is not initializing.
The DTCs run continuously when the above conditions are met.
P1017
- DTC P1015, P1016 or U010E is not set.
- The engine is running.
- The ignition voltage is greater than 11 V.
- The reductant control module is not initializing.
The DTCs run continuously when the above conditions are met.
P1018, P1019, P101A
- DTC P1015, P1016, P1017 or U010E is not set.
- The engine is running.
- The ignition voltage is greater than 11 V.
- The reductant control module is not initializing.
The DTCs run continuously when the above conditions are met.