LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2018 >> Equinox L >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 19 (Engine Controls And Fuel - 1.6L (LH7) Diesel - Diagnostic Information And Procedures (P040B - P204D)) >> Diagnostic Information And Procedures >> DTC P1005: Fuel Pump Driver Control Module Enable Too Many Resets >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different variant/trim than selected.
  1. Verify DTC U18A2 is not set.
    • Go to next step: If DTC U18A2 is not set 
  2. Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
  3. Verify the DTC does not set.
    • If the DTC sets 

      Refer to Circuit/System Testing.

    • Go to next step: If the DTC does not set 
  4. All OK.