Circuit/System Verification
WARNING: This page is about a different variant/trim than selected.
- Verify there is NO water in the fuel
Refer to Water-in-Fuel Draining
- If there is water in the fuel
Drain off the water completely.
- Go to next step: If there is No water in the fuel
- If there is water in the fuel
- Ignition ON.
- Verify the WATER IN FUEL message is not displayed.
- If the WATER IN FUEL message is displayed
Refer to Circuit/System testing.
- Go to next step: If the WATER IN FUEL message is not displayed
- If the WATER IN FUEL message is displayed
- All OK
NOTE:
If other contaminants are noticed in the fuel, a fuel system flush may be necessary.