LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2018 >> Equinox L >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 14 (Engine Controls And Fuel - 1.6L (LH7) Diesel - Repair Instructions) >> Repair Instructions >> Turbocharger Wastegate Actuator Pipe Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Remove Intake Manifold Cover. Refer to Intake Manifold Cover Replacement
  2. Remove the air cleaner outlet duct. Refer to Air Cleaner Outlet Duct Replacement 
    3. Fig 1: Turbocharger Wastegate Actuator Pipe And Turbocharger
    GM4197217Courtesy of GENERAL MOTORS COMPANY
  3. Remove Turbocharger Wastegate Actuator Pipe (2) @ Turbocharger (1)
    4. Fig 2: Turbocharger Wastegate Actuator Pipe Bolts, Nut And Clips
    GM4421811Courtesy of GENERAL MOTORS COMPANY
  4. Unclip Wiring Harness Clips (4) (Qty: 2)
  5. Remove Turbocharger Wastegate Actuator Pipe Bolts (1, 3) (Qty: 3)
  6. Remove the turbocharger wastegate actuator pipe nut (2).
    7. Fig 3: Turbocharger Wastegate Actuator Pipe And Power Brake Booster Inlet Hose Connector Fitting
    GM4197219Courtesy of GENERAL MOTORS COMPANY
  7. Disconnect Turbocharger Wastegate Actuator Pipe (1) @ Power Brake Booster Inlet Hose Connector Fitting (2)
  8. Remove Turbocharger Wastegate Actuator Pipe (1) @ Vehicle
scientia non olet · About LEMON Manuals