LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2018 >> Equinox L >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 14 (Engine Controls And Fuel - 1.6L (LH7) Diesel - Repair Instructions) >> Repair Instructions >> Emission Reduction Fluid Tank Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Remove Rear Bumper Fascia. Refer to Rear Bumper Fascia Replacement (Equinox)Rear Bumper Fascia Replacement (Terrain)
  2. Drain the emission reduction fluid tank. Refer to Emission Reduction Fluid Tank Draining 
  3. Remove Emission Reduction Fluid Tank Protector. Refer to Emission Reduction Fluid Tank Protector Replacement 
  4. Using only a low-pressure clean water hose, spray the upper and lower surface of the emission reduction fluid tank, emission reduction filler pipe and connections to remove dirt and debris.
  5. Using only a low pressure air wand or air gun, dry the emission reduction tank, emission reduction filler pipe and connections.
    6. Fig 1: Emission Reduction Fluid Exhaust Front Pipe Injector Supply Pipe, Electrical Connectors And Retainer
    GM4693538Courtesy of GENERAL MOTORS COMPANY
  6. Disconnect Electrical Connector (1)
  7. Remove Electrical Connector (1) @ Retainer (2)
  8. Disconnect Emission Reduction Fluid Exhaust Front Pipe Injector Supply Pipe Electrical Connector (3)
  9. Disconnect Emission Reduction Fluid Exhaust Front Pipe Injector Supply Pipe (4). Refer to Plastic Collar Quick Connect Fitting Service 
    10. Fig 2: Emission Reduction Fluid Tank Opening Filler Hoses
    GM4693541Courtesy of GENERAL MOTORS COMPANY
  10. Disconnect Emission Reduction Fluid Tank Opening Filler (1) (Qty: 2). Refer to Plastic Collar Quick Connect Fitting Service 
    11. Fig 3: Emission Reduction Fluid Tank Bolts
    GM4693547Courtesy of GENERAL MOTORS COMPANY
  11. Remove Emission Reduction Fluid Tank Bolts (1) (Qty: 2)
    12. Fig 4: Emission Reduction Fluid Tank And Bolts
    GM4693543Courtesy of GENERAL MOTORS COMPANY
  12. Remove Emission Reduction Fluid Tank Bolts (1) (Qty: 3)
  13. Remove Emission Reduction Fluid Tank (2)
    14. Fig 5: Emission Reduction Fluid Tank Bracket And Bolts
    GM4791610Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    If replacing the emission reduction fluid tank remove the metal mounting bracket.

  14. Remove Emission Reduction Fluid Tank Bracket Bolts (1) (Qty: 2)
  15. Remove Emission Reduction Fluid Tank Bracket (2)
  16. Transfer components as necessary.
scientia non olet · About LEMON Manuals