Emission Reduction Fluid Tank Draining

CAUTION:
The diesel exhaust fluid (DEF) system is part of the emission system for this vehicle, and must be serviced while observing extreme care to prevent foreign contamination of any kind from entering this system. If extreme care is NOT taken to prevent contamination from dirt, debris, fluids other than DEF, etc., reduced performance and/or damage to the DEF system may result.
• Cleanliness of the diesel exhaust fluid (DEF) system is crucial to ensure proper operation. Before opening any part of the DEF system, ensure connections and joints are thoroughly clean and dry of any dirt, debris, or other contaminants. Use only low pressure water and low pressure air, as directed.
• Diesel exhaust fluid (DEF) will have a tendency over time to develop areas of dried crystallization residue. Crystallization residue is a normal process for this fluid. Dried DEF crystallization residue can be wiped away, or flushed away with clean water, depending on location of the crystallization.
1. Ensure the ignition is OFF.
2. Using only a low pressure clean water hose, spray the filler hose cap and filler pocket to remove all dirt and debris.
3. Using only a low pressure air wand or air gun, direct air along the same surfaces to both dry and remove any further contaminants.
4. Remove the emission reduction fluid tank filler cap.
CAUTION:

The diesel exhaust fluid (DEF) must be drained by a clean dedicated siphoning pump and hose. It must NOT have any traces of gasoline, diesel fuel, or any oil based substances. If extreme care is NOT taken to prevent contamination from fluids other than DEF, reduced performance and/or damage to the DEF system may result.

5. Insert the hose from the pump devise into the emission reduction fluid tank.
6. Using a hand or air operated pump device, drain as much emission reduction fluid from the tank as possible into an approved container and dispose of properly.

Refilling Emission Reduction Fluid Tank

1. Refill the emission reduction fluid tank, add a minimum of 9.5 liters (2.5 gallons).
2. Perform the reductant fluid tank level reset. Refer to Reductant Fluid Tank Level Reset