Circuit/System Verification
WARNING: This page is about a different variant/trim than selected.
- Ignition ON, verify that the EGR Position Sensor parameter reading is between 0.25 - 4.75 V.
- If not within the specified range
Refer to DTC P0404-P0406 .
- Go to next step: If within the specified range
- If not within the specified range
- Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
- Verify that DTC P042E or P042F does not set.
- If the DTC sets
Refer to Circuit/System Testing.
- Go to next step: If the DTC does not set
- If the DTC sets
- All OK.