Circuit/System Testing
WARNING: This page is about a different variant/trim than selected.
NOTE:
Perform the Circuit/System Verification before proceeding with Circuit/System Testing.
- Verify the conditions listed below do not exist:
- Restrictions in the EGR cooler, EGR cooler bypass valve and passages.
- Wet or restricted air filter.
- Loose or improperly connected hoses.
- Damaged or missing components.
- Induction/charge air cooler system restrictions.
- Exhaust system restrictions.
- Binding, damaged or restricted intake air flow valve.
- Binding, damaged or restricted EGR valve.
- Induction/charge air cooler system leaks. Refer to Charge Air Cooler Diagnosis (Leak Test)Charge Air Cooler Diagnosis (Smoke Test) - Induction System Smoke Test and Full System Air Leak Test.
- Exhaust system/turbo charger leaks.
- Restrictions or damage to the turbocharger.
- If a condition exists
Repair or replace the component as necessary.
- Go to next step: If none of the conditions exist
- Test or replace the Q14 Exhaust Gas Recirculation Valve.