Circuit/System Verification
WARNING: This page is about a different variant/trim than selected.
- Do not replace the engine control module for these informational DTCs.
- Correct any engine control and communication DTCs before diagnosing these DTCs.
- Vehicle in Service Mode.
- Verify there are no engine control or communication DTCs set.
- If a DTC is set
Refer to Diagnostic Trouble Code (DTC) List - Vehicle .
- Go to next step: If a DTC is not set
- If a DTC is set
- Verify there are no DTCs set in any other control module.
- If a DTC is set
Refer to Diagnostic Trouble Code (DTC) List - Vehicle .
- Go to next step: If a DTC is not set
- If a DTC is set
- Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
- Verify the DTC does not set.
- If the DTC sets
Refer to Diagnostic Trouble Code (DTC) List - Vehicle .
- Go to next step: If the DTC does not set
- If the DTC sets
- All OK.
NOTE: