LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2018 >> Equinox L >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 13 (Engine Controls And Fuel - 1.6L (LH7) Diesel - Diagnostic Information And Procedures (P0016 - P049D)) >> Diagnostic Information And Procedures >> DTC P0096 Or P0111: Intake Air Temperature (IAT) Sensor 1/2 Performance >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different variant/trim than selected.
  1. Ignition On.
  2. Verify that DTC P00EA, P00EB, P00EC, P0097, P0098, P0099, P00F4, P00F5, P00F6, P0102, P0103, P0112, P0113, P0114, P0641, P0651, P0697, or P06A3 is not set.
    • Go to next step: If none of the DTCs are set 
    3. NOTE:

    To minimize the effects of residual engine heat and sensor internal heating elements, perform Steps 3 and 4 of this verification procedure only if the ignition has been OFF for 8 hours or more.

  3. Ignition On.
  4. Verify the following scan tool parameters are within 25°C (45°F) of each other.
    • Start-Up IAT Sensor 1
    • Start-Up IAT Sensor 2
    • Start-Up IAT Sensor 3
    • If not within 25°C (45°F) 

      Refer to Circuit/System Testing.

    • Go to next step: If within 25°C (45°F) 
  5. Engine running.
  6. Verify the following scan tool parameters are between: -38 and +149°C (-36 and +300°F).
    • IAT Sensor 1
    • IAT Sensor 2
    • If not between: -38 and +149°C (-36 and +300°F) 

      Refer to Circuit/System Testing.

    • Go to next step: If between: -38 and +149°C (-36 and +300°F) 
  7. Operate the vehicle within the conditions for running the DTC. You may also operate the vehicle within the conditions that you observed from the freeze frame/failure records data.
  8. Verify the DTC does not set.
    • If the DTC sets 

      Refer to Circuit/System Testing.

    • Go to next step: If the DTC does not set 
  9. All OK
scientia non olet · About LEMON Manuals