LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2018 >> Equinox L >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 13 (Engine Controls And Fuel - 1.6L (LH7) Diesel - Diagnostic Information And Procedures (P0016 - P049D)) >> Diagnostic Information And Procedures >> DTC P0016: Crankshaft Position - Camshaft Position Not Plausible >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different variant/trim than selected.
  1. Ignition - On/Vehicle - In Service Mode
  2. Verify DTC P0335, P0336, P0340, P0341 is not set.
    • Go to next step: If none of the DTCs are set 
  3. Engine - Idling - At normal operating temperature
  4. Verify DTC P0016 is not set.
    • If the DTC is set 
    1. Ignition/Vehicle - Off
    2. Verify the following conditions do not exist:
      • B23 Camshaft Position Sensor - Incorrect installation
      • B26 Crankshaft Position Sensor - Incorrect installation
      • Reluctor Ring - Misaligned @ Crankshaft
      • Timing Chain - Excessive play
      • Timing Chain Tensioner - Incorrect installation
      • If a condition exists - Repair or replace as necessary
      • If none of the conditions exists - Refer to step 2.
    • Go to next step: If the DTC is not set 
  5. Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.

    Verify the DTC does not set.

    • If the DTC sets 

      One of the above conditions still exist.

    • Go to next step: If the DTC is not set 
  6. All OK.
scientia non olet · About LEMON Manuals