LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2017 >> Spark LT, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 86 (Front Suspension System) >> Repair Instructions >> Wheel Stud Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2019 Buick Cascada, 2018 Buick Cascada, and 2017 Buick Cascada. However, it is still accessible from the selected car via links, so may be relevant.
  1. GM2027808

    Install a NEW stud into the bearing/hub assembly (2). Add enough washers (3) in order to draw the stud into the hub.

  2. Install and tighten a wheel nut (1) until the head of the wheel stud is fully seated against the back of the bearing/hub flange (2).
  3. Remove the wheel nut (1) and the washers (3).
  4. Install the wheel bearing/hub (2). Refer to Front Wheel Bearing and Hub Replacement .
  5. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
  6. Remove the support and lower the vehicle.
scientia non olet · About LEMON Manuals