Exhaust Pipe Front Hanger Bracket Replacement

WARNING: This page is about a different car, the 2019 Buick Cascada. However, it is still accessible from the selected car via links, so may be relevant.

Callout	Component Name
WARNING: Refer to Exhaust Service Warning . WARNING: Refer to Protective Goggles and Glove Warning . Preliminary Procedures Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle . Remove the underbody brace - front. Refer to Underbody Brace Replacement - Front . Remove the underbody brace - middle. Refer to Underbody Brace Replacement - Middle X-Rod . Special Tools EN-45059 Angle MeterFor equivalent regional tools, refer to Special Tools .
1	Exhaust Pipe Front Hanger Insulator Nut (Qty: 2) CAUTION: Refer to Fastener Caution . Tighten 17 N.m (13 lb ft)
2	Exhaust Pipe Front Hanger Bracket Bolt (Qty: 2) CAUTION: Refer to Torque-to-Yield Fastener Caution . Procedure Install NEW bolts, do NOT reuse old bolts. Tighten First Pass: 22 N.m (16 lb ft). Final Pass: 30 - 45 degrees, using the EN-45059 meter.
3	Drivetrain and Front Suspension Frame Support Bolt (Qty: 2) Procedure Install NEW bolts, do NOT reuse old bolts. Tighten First Pass: 60 N.m (44 lb ft). Final Pass: 30 - 45 degrees, using the EN-45059 meter.
4	Exhaust Pipe Front Hanger Bracket