LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2017 >> Spark LT, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 62 (Automatic Transmission Cooling System) >> Repair Instructions >> Transmission Fluid Cooler Inlet Pipe Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2019 Buick Cascada, 2018 Buick Cascada, and 2017 Buick Cascada. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the battery tray. Refer to Battery Tray Replacement .
  2. Remove the underbody brace - front. Refer to Underbody Brace Replacement - Front .
  3. Drain the transmission fluid. Refer to Transmission Fluid Drain and Fill .
  4. GM2918322

    Install a suitable container to catch the transmission fluid if it drips out of the connector and the pipe.

  5. Disconnect the transmission fluid cooler inlet pipe (2) from the transmission fluid cooler pipe - front (1). Refer to Transmission Fluid Cooler Hose/Pipe Quick-Connect Fitting Disconnection and Connection .
  6. GM2918323

    Remove the transmission fluid cooler inlet pipe nut (3) from the stud (4).

  7. Remove the transmission fluid cooler inlet pipe (6) from the retainers (1, 2).
  8. Remove the transmission fluid cooler inlet pipe (6) and DISCARD the transmission fluid cooler inlet pipe seal.
scientia non olet · About LEMON Manuals