LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2017 >> Spark LT, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 58 (Engine Controls And Fuel - 1.6L (LWC) - Repair Instructions) >> Repair Instructions >> Knock Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2019 Buick Cascada, 2018 Buick Cascada, and 2017 Buick Cascada. However, it is still accessible from the selected car via links, so may be relevant.
  1. GM2968024

    Pre-install the knock sensor (2).

  2. Pre-install the knock sensor bolt (1).
  3. GM2968025
    NOTE:

    The knock sensor connector must be oriented as shown (a).

    Position the knock sensor 20 degrees (a) out of horizontal position.

    4. CAUTION:

    Refer to Fastener Caution .

  4. Tighten the knock sensor bolt (1) to 22 N.m (16 lb ft).
  5. Connect the knock sensor wiring harness plug.
  6. Install the underbody brace - front. Refer to Underbody Brace Replacement - Front .
  7. Install the engine shield, if equipped. Refer to Engine Shield Replacement .
  8. Lower the vehicle.
  9. Connect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection .
scientia non olet · About LEMON Manuals