LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2017 >> Spark LT, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 58 (Engine Controls And Fuel - 1.6L (LWC) - Repair Instructions) >> Repair Instructions >> Evaporative Emission Front Pipe Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2019 Buick Cascada, 2018 Buick Cascada, and 2017 Buick Cascada. However, it is still accessible from the selected car via links, so may be relevant.
  1. GM2191588

    Install the evaporative emission front pipe (3) and close the fuel pipe clip (2).

  2. Connect the emission canister fuel vent pipe (1) to the evaporative emission front pipe (3). Refer to Plastic Collar Quick Connect Fitting Service .
  3. GM2191622

    Install the lower bulk head clip.

  4. Close the 4 fuel pipe clips (2).
  5. GM2969114

    Install the right front compartment front panel (3).

    6. CAUTION:

    Refer to Fastener Caution .

  6. Install the front compartment front panel bolts (2) and tighten to 100 N.m (74 lb ft).
  7. Install the frame rear bolts (1) and tighten to 160 N.m (118 lb ft).
  8. Underbody Brace Replacement - Middle X-Rod - Install
  9. Underbody Brace Replacement - Front - Install
  10. Lower the vehicle.
  11. GM3011731

    Install the evaporative emission front pipe (1) to the upper bulkhead clip (3).

  12. Close the upper bulkhead clip (3).
  13. Clip in the evaporative emission front pipe into clip (2).
  14. GM3011730

    Connect the evaporative emission front pipe (1) to the evaporative emission canister purge solenoid valve (2). Refer to Plastic Collar Quick Connect Fitting Service .

  15. Engine Sight Shield Replacement - Install
  16. Connect the battery negative cable. Battery Negative Cable Disconnection and Connection .
scientia non olet · About LEMON Manuals