LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2017 >> Spark LT, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 40 (Seat Hardware, Seat Trim, And Upholstery) >> Repair Instructions >> Front Seat Cushion Side Finish Panel Replacement

Front Seat Cushion Side Finish Panel Replacement

WARNING: This page is about a different car, the 2019 Buick Cascada, 2018 Buick Cascada, and 2017 Buick Cascada. However, it is still accessible from the selected car via links, so may be relevant.
GM2190013
Callout Component Name

Preliminary Procedures

  1. Remove the driver or passenger seat adjuster vertical actuator handle, if equipped. Refer to Driver or Passenger Seat Adjuster Vertical Actuator Handle Replacement .
  2. Remove the driver or passenger seat recliner lever, if equipped. Refer to Driver or Passenger Seat Recliner Lever Replacement .
  3. Remove the front seat tilt adjuster lever, if equipped. Refer to Front Seat Tilt Adjuster Lever Replacement .
1 Front Seat Cushion Side Finish Panel Bolt (Qty: 3)
CAUTION:

Refer to Fastener Caution .
2 Front Seat Cushion Side Finish Panel

Procedure

  1. Disconnect three wiring harness connectors, if equipped.
  2. If replacing the front seat cushion side finish panel, transfer the driver or passenger seat lumbar control, the vertical seat adjustment switch and the seat tilt adjustment switch, if equipped. Refer to Driver or Passenger Seat Lumbar Control Switch Replacement .
scientia non olet · About LEMON Manuals