Ignition and Start Switch Housing Replacement

WARNING: This page is about a different car, the 2019 Buick Cascada, 2018 Buick Cascada, and 2017 Buick Cascada. However, it is still accessible from the selected car via links, so may be relevant.

Callout	Component Name
Preliminary Procedures Remove the ignition lock cylinder. Refer to Ignition Lock Cylinder Replacement Remove the turn signal switch bracket. Refer to Turn Signal Switch Bracket Replacement
1	Ignition Lock Cylinder Bolt CAUTION: Refer to Fastener Caution . Procedure Use a suitable chisel to remove bolt. Install NEW bolt and tighten until head tears off.
2	Ignition and Start Switch Housing Procedure Disconnect the electrical connector. Remove ignition and start switch. Refer to Ignition and Start Switch Replacement .

Callout

Component Name

Preliminary Procedures

Remove the ignition lock cylinder. Refer to Ignition Lock Cylinder Replacement
Remove the turn signal switch bracket. Refer to Turn Signal Switch Bracket Replacement

Ignition Lock Cylinder Bolt

CAUTION:

Refer to Fastener Caution .

Procedure

Use a suitable chisel to remove bolt.
Install NEW bolt and tighten until head tears off.

Ignition and Start Switch Housing

Procedure

Disconnect the electrical connector.
Remove ignition and start switch. Refer to Ignition and Start Switch Replacement .