LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2017 >> Malibu LS >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 9 (Automatic Transmission - 5ET50 (MKE)) >> Repair Instructions - On Vehicle >> Transmission Rear Mount Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Install the rear transmission mount (3).
    Fig 1: Transmission Rear Mount
    GM4282649Courtesy of GENERAL MOTORS COMPANY
  2. Install the NEW rear transmission mount to frame bolt (2) and nut then tighten to 100 N.m (74 lb ft) plus 120 - 135 degrees.
    CAUTION: Refer to Torque-to-Yield Fastener Caution .
    CAUTION: Refer to Fastener Caution .
  3. Install the rear transmission mount bracket to rear mount through bolt (1) and tighten to 70 N.m (52 lb ft) plus 90 - 105 degrees
  4. Install the front exhaust pipe. Refer to Exhaust Front Pipe Replacement (LTG)Exhaust Front Pipe Replacement (LFV)Exhaust Front Pipe Replacement (LKN) .
scientia non olet · About LEMON Manuals