Installation Procedure

WARNING: This page is about a different variant/trim than selected.

Variable Low Clutch Fluid Passage Seal (7) - Install

Fig 1: Control Valve Body Components
Courtesy of GENERAL MOTORS COMPANY

NOTE: Install a NEW seal.
Control Valve Lower Body Spacer Plate (6) - Install
NOTE: Install a NEW spacer plate.
Control Valve Body Spacer Plate Retainer (5) - Install [2x]
Control Valve Body (4) - Install
Control Valve Body Bolt (3) - Install [13x] - Hand tighten
CAUTION: Fastener Caution
Fluid Transfer Pipe (2) - Install
Fluid Transfer Pipe Bolt (1) - Install - Hand tighten
Connect the control valve body wiring harness.
Control Valve Body Bolt @ Fluid Transfer Pipe Bolt - Tighten in sequence 9 N.m (80 lb in)

Fig 2: Control Valve Body Bolt And Fluid Transfer Pipe Bolt Tightening Sequence
Courtesy of GENERAL MOTORS COMPANY
Control Solenoid Valve Filter Plate (3) - Install

Fig 3: Control Valve Body Bolts, Control Solenoid Valve And Filter Plate
Courtesy of GENERAL MOTORS COMPANY
Control Solenoid Valve (2) - Install
Control Valve Body Bolt (1) - Install [4x] - Hand tighten
Connect the control solenoid valve wiring harness.
Control Valve Body Bolt - Tighten in sequence 9 N.m (80 lb in)

Fig 4: Control Valve Body Bolts Tightening Sequence
Courtesy of GENERAL MOTORS COMPANY
Control Valve Body Cover Replacement - Install