Holding Fixture Removal

WARNING: This page is about a different variant/trim than selected.

Fig 1: Holding Fixture Assembly

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
1	WARNING: Handle with care, the transmission assembly weighs over 183 Kg (403 lbs). Bodily injury could occur if not handled properly. Procedure Install DT-46625 Holding Fixture. Remove lock pin from DT-3289-20 Holding Fixture. Raise the transmission with an overhead hoist in order to remove the holding DT-46625 Transmission Holding Fixture. Lower the transmission assembly onto the transmission jack. Special Tools DT-03289-20 Holding Fixture Base Assembly DT-46625 Holding Fixture DT-46625-20 Holding Fixture Adapters For equivalent regional tools, refer to Special Tools .

Callout

Component Name

WARNING: Handle with care, the transmission assembly weighs over 183 Kg (403 lbs). Bodily injury could occur if not handled properly.

Procedure

Install DT-46625 Holding Fixture.
Remove lock pin from DT-3289-20 Holding Fixture.
Raise the transmission with an overhead hoist in order to remove the holding DT-46625 Transmission Holding Fixture.
Lower the transmission assembly onto the transmission jack.

Special Tools

For equivalent regional tools, refer to Special Tools .