Automatic Transmission Wiring Harness Removal

WARNING: This page is about a different variant/trim than selected.

Fig 1: Automatic Transmission Wiring Harness

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
Preliminary Procedure Disconnect the wiring harness connector from the manual shift detent lever and remove the connectors from the wiring harness brackets noting location for installation. Remove the manual shift detent lever spring to aid in removal of the transmission wiring harness.
1	Automatic Transmission Wiring Harness - Control Solenoid Valve
2	Automatic Transmission Wiring Connector Seal
3	Automatic Transmission Wiring Harness - Shift Shaft Position Switch
4	Automatic Transmission Wiring Connector Seal